B0010 Possible Causes
- Faulty Passenger Airbag
- Passenger Airbag harness is open or shorted
- Passenger Airbag circuit poor electrical connection
First diagnose B0010 code
Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.
Cost of diagnosing the B0010 code
Labor: 1.0The cost of diagnosing the B0010 code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
When is the B0010 code detected?If the Restraints Control Module (RCM) detects a short between the passenger air bag stage 1 circuits and the circuits of another SRS component, it sets this Diagnostic Trouble Code (DTC) and the DTC of the corresponding SRS component.
B0010 Possible Symptoms
- Air Bag Warning Light ON
B0010 MeaningThe Restraints Control Module (RCM) monitors all deployable device and sensor circuits for a signal cross coupled (short) between circuits. If the RCM detects a short between the circuits of one device and another device, it will store a DTC for each of the signal cross coupled faults in memory. The RCM sends a message to the Instrument Panel Cluster (IPC) to illuminate the air bag warning indicator. When a normal loop fault is present (one loop is either shorted to battery/ground, open circuit or low resistance), then signal cross coupled diagnostics will not be active. Once the normal loop fault is repaired, then the signal cross coupled diagnostics will resume.
B0010 More InformationNeed more information on how to fix the B0010 code?
Get Access to Factory Service Manuals
B0010 Information for specific makes
- B0010 ACURA Decreased Resistance In The Passenger Airbag First Inflator
- B0010 CHRYSLER Passenger Frontal Squib 1 Control
- B0010 DODGE Passenger Frontal Squib 1 Control
- B0010 FORD Passenger Frontal Stage 1 Deployment Control
- B0010 HONDA Decreased Resistance In The Passenger Airbag First Inflator
- B0010 INFINITI Passenger Air Bag Module
- B0010 JEEP Passenger Frontal Squib 1 Control
- B0010 LINCOLN Passenger Frontal Stage 1 Deployment Control
- B0010 MERCURY Passenger Frontal Stage 1 Deployment Control
- B0010 NISSAN Passenger Air Bag Module
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.