B0010 HONDA - Decreased Resistance In The Passenger Airbag First Inflator
B0010 HONDA Possible Causes
- Faulty Passenger Side Airbag
- Passenger Side Airbag harness is open or shorted
- Passenger Side Airbag circuit poor electrical connection
- Faulty Steering Wheel Clockspring
First diagnose B0010 HONDA code
Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.
B0010 HONDA Tech NotesB0010-1A: Decreased Resistance In The Passenger side Airbag First Inflator DTC
B0010-11: Short To Ground In The Passenger side Airbag First Inflator
B0010-12: Short To Power In The Passenger side Airbag First Inflator
B0010-13: Open Or Increased Resistance In The Passenger side Airbag First Inflator
Cost of diagnosing the B0010 HONDA code
Labor: 1.0The cost of diagnosing the B0010 HONDA code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
B0010 HONDA Possible Symptoms
- Air Bag Warning Light ON
B0010 HONDA MeaningThe Driver Side Airbag is located in the center of the steering wheel. The front passenger side airbag is located in the dashboard on the front passenger side. The airbag modules adopt dual inflators for the driver side and/or the front passenger side airbag according to the specifications. The dual inflators increase airbag effectiveness by properly adjusting the timing when the two inflators are ignited (together or sequentially) referring to the collision speed or collision impact.
B0010 HONDA More InformationNeed more information on how to fix the B0010 HONDA code?
Get Access to Factory Service Manuals
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.