Engine-Codes - Gmc - P10E2 GMC

P10E2 GMC Code - Ignition On/Start Circuit Source Bypass Relay Control Circuit Low Voltage

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3
Table of contents

|P10E2 GMC code possible causes

  • Faulty Engine Control Module Wake-Up Relay
  • Engine Control Module Wake-Up Relay harness is open or shorted
  • Engine Control Module Wake-Up Relay circuit poor electrical connection
  • Faulty Engine Control Module (ECM)

|How is the P10E2 GMC code repair?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|What is the cost to diagnose the P10E2 GMC code

Labor: 1.0

The cost to diagnose the P10E2 GMC code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are P10E2 GMC code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|What is P10E2 GMC code meaning?

The Engine Control Module (ECM) contains a microprocessor used to process input data to control outputs. The control module controls a series of actuators to ensure optimal engine performance. The control module does this by reading values from a variety of sensors, interprets the data and adjusts the engine actuators accordingly. Relays are used to control a high-power circuit with a low power signal. The output circuit is switched to the ground to activate the component. The Diagnostic Trouble Code (DTC) will be set when the Control Circuit is short to ground for greater than 1 s.

|Need more information with the P10E2 GMC code?

Need more information on how to fix the P10E2 GMC code?
Get Access to Factory Service Manuals

|Need help with a P10E2 GMC code?

Get the P10e2 Gmc code diagnosed by a professional: Find a repair shop in your area