Engine-Codes - GMC - P100E GMC

P100E GMC Code - Accelerator Pedal Position Signal Message Counter Incorrect

- Code Popularity: 100 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents

|What are the Possible Causes of the Code P100E GMC?

  • Faulty Accelerator Pedal Position Sensor
  • Accelerator Pedal Position Sensor harness is open or shorted
  • Accelerator Pedal Position Sensor circuit poor electrical connection

|How to Fix the P100E GMC Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|What is the Cost to Diagnose the Code P100E GMC?

Labor: 1.0

The cost to diagnose the P100E GMC code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

Does your GMC have Safety Recalls? → Check here

|What are Code P100E GMC Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|What Does the P100E GMC Code Mean?

Control modules connected to the serial data circuits monitor the communication during normal vehicle operation. Operating information and commands are exchanged among the control modules. Each module on the serial data circuit maintains a transmit error counter and a receive error counter. The counter values increase with detected errors and decrease with error-free messages. The Diagnostic Trouble Code (DTC) will be set when the Accelerator Pedal Position Signal Message Counter is Incorrect.

P100E GMC Code - Accelerator Pedal Position Signal Message Counter Incorrect

|Need more Information on the P100E GMC Code?

Need more information on how to fix the P100E GMC code? Get Access to Factory Service Manuals

|Need Help with the P100E GMC Code?

Get the P100E GMC code diagnosed by a professional: Find a repair shop in your area