P0155 FORD - O2 Heater Circuit Bank 2 Sensor 1
P0155 FORD Possible Causes
- Faulty Heated Oxygen Sensor (H2OS) Bank 2 Sensor 1
- Heated Oxygen Sensor (H2OS) Bank 2 Sensor 1 circuit fuse
- Heated Oxygen Sensor (H2OS) Bank 2 Sensor 1 harness is open shorted to ground
- Heated Oxygen Sensor (H2OS) Bank 2 Sensor 1 circuit poor electrical connection
- Faulty Engine Control Module (ECM)
How is the P0155 FORD code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the P0155 FORD code
Labor: 1.0The cost to diagnose the P0155 FORD code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
When is the code detected?The current amperage in the front heated oxygen sensor heater circuit is out of the normal range. (An improper voltage drop signal is sent to ECM through the front heated oxygen sensor heater)
- Engine Light ON (or Service Engine Soon Warning Light)
- Possible higher fuel consumption
- Possible more smoke from exhaust than usual
P0155 FORD MeaningOxygen Sensors (O2S) or Heated Oxygen Sensors (HO2S) need to reach a minimum operating temperature of 750 degrees F to produce an accurate voltage signal. The faster the heated oxygen sensor reaches that temperature the faster the sensor will start sending an accurate signal to the Engine Control Module (ECM). In order to achieve the require temperature, a heater element is included inside the heated oxygen sensor. The ECM controls the heated oxygen sensor heater element based on signals from the engine coolant temperature and engine load. The ECM controls the heater element circuit by allowing current flow to ground. The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.
More InformationNeed more information on how to fix the P0155 FORD code?
Get Access to Factory Service Manuals
Information for specific Ford models
- P0155 1997 FORD F150
- P0155 1998 FORD F150
- P0155 1999 FORD F150
- P0155 2000 FORD F150
- P0155 2001 FORD F150
- P0155 2002 FORD F150
- P0155 2003 FORD F150
- P0155 2006 FORD FUSION 📷
- P0155 2007 FORD FUSION 📷
- P0155 2008 FORD FUSION 📷
- P0155 2009 FORD FUSION 📷
- P0155 2010 FORD FUSION 📷
- P0155 2011 FORD FUSION 📷
- P0155 2012 FORD FUSION 📷