U1470 - Implausible Data Received From Left Impact Pressure Sensor
U1470 Possible Causes
- Faulty Left Impact Pressure Sensor
- Left Impact Pressure Sensor harness is open or shorted
- Left Impact Pressure Sensor circuit poor electrical connection
- Faulty Occupant Restraint Controller (ORC)
How is the U1470 code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the U1470 code
Labor: 1.0The cost to diagnose the U1470 code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
- Air Bag Warning Light ON
U1470 MeaningSix side impact sensors are used on vehicles equipped with side curtain airbags, three on each side of the vehicle. One acceleration-type sensor is located behind the B-pillar trim near the base of each B-pillar, and one acceleration-type sensor is located behind the quarter panel trim near the base of each C-pillar. One pressure-type sensor is located on each front poor hardware carrier panel, concealed behind each front door inside the trim panel. The driver door pressure sensor is mounted to the driver inner door panel behind the door trim panel. The impact sensors perform their own self test using power supplied by the Occupant Restraint Controller (ORC) then communicate this status back to the ORC with periodic updates. The repair of this fault condition involves verifying the integrity of the wiring between the ORC and the sensor. The door pressure sensor is hardwired to the Occupant Restraint Controller (ORC).
This code will set, if the ORC and the Driver Door Pressure Sensor (Satellite) do not establish and maintain valid data communications. The Diagnostic Trouble Code (DTC) will become Active after the fault has set for a minimum of 100 milliseconds (ms). The DTC will go to Stored after the ORC to Driver Door Pressure Sensor (Satellite) communication fault has been removed or the suspect pressure sensor has been replaced. The clearing of this fault is immediate upon the suspect internal error being removed or the suspect sensor replaced. The Multifunction Indicator Lamp (MIL) will set in the instrument cluster.
More InformationNeed more information on how to fix the U1470 code?
Get Access to Factory Service Manuals
Information for specific makes
Need more help?Get the U1470 code diagnosed by a professional: Find a repair shop in your area
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.