According to some AutoCodes.com users, the code could be triggered by disconnecting or recharging the car battery. Before replacing any parts, clear the code and drive your vehicle for more than 50 miles and/or a few days.
⚠ Does your Hyundai have Safety Recalls? → Check here
How to Fix the DTC P0106 Hyundai?
Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.
Search for P0106 Hyundai Questions and Answers: Search here →
What is the Cost to Diagnose the Code?
Labor: 1.0
The cost to diagnose the P0106 Hyundai code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.
What are Code Possible Symptoms?
Engine Light ON (or Service Engine Soon Warning Light)
Engine rough idle
Engine hesitation
What Does the P0106 Hyundai Code Mean?
The Manifold Absolute Pressure (MAP) sensor measures the pressure inside the intake manifold. Pressure in the intake manifold is affected by engine speed, throttle opening, air temperature, Barometric Pressure (BARO) and if equipped, turbocharger output. A diaphragm within the MAP sensor is displaced by the pressure changes that occur from the varying load and operating conditions of the engine. The sensor translates this action into electrical resistance.
The MAP sensor wiring includes 3 circuits. The Engine Control Module (ECM) supplies a regulated 5 volts to the sensor on a 5 V reference circuit. The ECM supplies ground on a low reference circuit. The MAP sensor provides a signal voltage to the ECM, relative to the pressure changes, on the MAP sensor signal circuit. The ECM converts the signal voltage input to a pressure value.
Under normal operation the greatest pressure that can exist in the intake manifold is at ignition ON, engine OFF, which is equal to the BARO. The lowest manifold pressure occurs when the vehicle is idling or decelerating. The ECM monitors the MAP sensor signal for pressure outside of the normal range.
The Diagnostic Trouble Code (DTC) will be set when the ECM determines the MAP Sensor is stuck within the normal operating range. It accomplishes this by running 3 different models within the software to determine the values.
P0106 Hyundai Code - Manifold Absolute Pressure/Barometric Pressure Circuit Range/Performance Problem