Engine-Codes - Generic - B1992

B1992 Code - Driver Side Side Mount Airbag Circuit Short To Battery Voltage

- Code Popularity: 3,959 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
What is this?
Table of contents
What does this mean?

What are the Possible Causes of the Code B1992?

  • Faulty Driver Side Side Mount Airbag
  • Driver Side Side Mount Airbag harness is open or shorted
  • Driver Side Side Mount Airbag circuit poor electrical connection
  • Faulty Restraints Control Module (RCM)

How to Fix the B1992 Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Search B1992 Questions and Answers

What is the Cost to Diagnose the Code B1992?

Labor: 1.0

The cost to diagnose the B1992 code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

Does your Car have Safety Recalls? → Check here

What are Code B1992 Possible Symptoms?

  • Air Bag Warning Light ON

What Does the B1992 Code Mean?

The Restraints Control Module (RCM) monitors the Driver Side Side Mount Airbag. The RCM sets the OBDII code when the Driver Side Side Mount Airbag is not to factory specifications.

B1992 Code - Driver Side Side Mount Airbag Circuit Short To Battery Voltage

Need more Information on the B1992 Code?

Need more information on how to fix the B1992 code? Get Access to Factory Service Manuals

Code B1992 Information for Specific Makes

  • B1992 Chrysler Right Power Sliding Door Sensor Supply Circuit High
  • B1992 Dodge Right Power Sliding Door Sensor Supply Circuit High
  • B1992 Ford Driver Side Side Mount Airbag Circuit Short To Battery Voltage
  • B1992 Jeep Right Power Sliding Door Sensor Supply Circuit High
  • B1992 Lincoln Driver Side Side Mount Airbag Circuit Short To Battery Voltage
  • B1992 Mercury Driver Side Side Mount Airbag Circuit Short To Battery Voltage
  • B1992 RAM Right Power Sliding Door Sensor Supply Circuit High

Need Help with the B1992 Code?

Get the B1992 code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Related Information