Engine-Codes - Generic - B0960

B0960 Code - Parking Aid Rear Sensor 1 Right Middle Circuit

- Code Popularity: 4,071 Views
- Repair Importance Level: 1/3
- Repair Difficulty Level: 2/3
Table of contents

|What are the Possible Causes of the Code B0960?

  • Faulty Parking Aid Rear Sensor 1 Right Middle
  • Parking Aid Rear Sensor 1 Right Middle harness is open or shorted
  • Parking Aid Rear Sensor 1 Right Middle circuit poor electrical connection

|How to Fix the B0960 Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|Code B0960 Tech Notes

B0960 01 Parking Aid Rear Sensor 1 Right Middle Circuit Short to Battery
B0960 06 Parking Aid Rear Sensor 1 Right Middle Circuit Short to Ground or Open
B0960 08 Parking Aid Rear Sensor 1 Right Middle Circuit Signal Invalid
B0960 21 Parking Aid Rear Sensor 1 Right Middle Circuit Incorrect Period

|What is the Cost to Diagnose the Code B0960?

Labor: 1.0

The cost to diagnose the B0960 code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

Does your car have Safety Recalls? → Check here

|What are Code B0960 Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|What Does the B0960 Code Mean?

The object alarm detection system senses how close the vehicle is to an object. The distance is determined by the 4 ultrasonic sensors located in the rear bumper. The object detection system will notify the driver when backing up at speeds less than 8 km/h (5 mph), which make parking easier and helps you avoid colliding with objects such as parked vehicles. Each object sensor is a 3-wire sensor that is both a transmitter and a receiver that comprises a signal circuit, a low reference circuit, and an 8-volt supply voltage circuit. The rear object control module supplies 8 volts to the object sensors via the object sensor supply voltage circuit and provides ground via the low reference circuit. The rear object control module triggers the sensors in a sequential loop and after each sensor transmits, the rear object control module uses the echo or signal return to calculate the distance and position of an object from the rear bumper. The rear object control module directly controls the Rear Parking Assist (RPA) display. The RPA consists of 2 amber and one red LED that indicates the range of an object from the rear bumper. The rear object control module will also use an audible warning by sending a low speed GMLAN message to the radio.

Parking Aid Rear Sensor 1 Right Middle Circuit

|Need more Information on the B0960 Code?

Need more information on how to fix the B0960 code? Get Access to Factory Service Manuals

|Code B0960 Information for Specific Makes

|Need Help with the B0960 Code?

Get the B0960 code diagnosed by a professional: Find a repair shop in your area