B0960 CHEVROLET Code - Parking Aid Rear Sensor 1 Right Middle Circuit
|B0960 CHEVROLET code possible causes
- Faulty Parking Aid Rear Sensor 1 Right Middle
- Parking Aid Rear Sensor 1 Right Middle harness is open or shorted
- Parking Aid Rear Sensor 1 Right Middle circuit poor electrical connection
|How is the B0960 CHEVROLET code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|B0960 CHEVROLET code tech notesB0960 01 Parking Aid Rear Sensor 1 Right Middle Circuit Short to Battery
B0960 06 Parking Aid Rear Sensor 1 Right Middle Circuit Short to Ground or Open
B0960 08 Parking Aid Rear Sensor 1 Right Middle Circuit Signal Invalid
B0960 21 Parking Aid Rear Sensor 1 Right Middle Circuit Incorrect Period
|What is the cost to diagnose the B0960 CHEVROLET code
Labor: 1.0The cost to diagnose the B0960 CHEVROLET code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|What are B0960 CHEVROLET code possible symptoms?
- Engine Light ON (or Service Engine Soon Warning Light)
|What is B0960 CHEVROLET code meaning?The object alarm detection system senses how close the vehicle is to an object. The distance is determined by the 4 ultrasonic sensors located in the rear bumper. The object detection system will notify the driver when backing up at speeds less than 8 km/h (5 mph), which make parking easier and helps you avoid colliding with objects such as parked vehicles. Each object sensor is a 3-wire sensor that is both a transmitter and a receiver that comprises a signal circuit, a low reference circuit, and an 8-volt supply voltage circuit. The rear object control module supplies 8 volts to the object sensors via the object sensor supply voltage circuit and provides ground via the low reference circuit. The rear object control module triggers the sensors in a sequential loop and after each sensor transmits, the rear object control module uses the echo or signal return to calculate the distance and position of an object from the rear bumper. The rear object control module directly controls the Rear Parking Assist (RPA) display. The RPA consists of 2 amber and one red LED that indicates the range of an object from the rear bumper. The rear object control module will also use an audible warning by sending a low speed GMLAN message to the radio.
|Need more information with the B0960 CHEVROLET code?Need more information on how to fix the B0960 CHEVROLET code?
Get Access to Factory Service Manuals