Engine-Codes - Ford - U3000 Ford

U3000 Ford Code - Control Module Failure or Erratic

- Code Popularity: 120,443 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC U3000 Ford?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Control Module
  • Control Module harness is open or shorted
  • Control Module circuit poor electrical connection

Code Tech Notes

U3000:42 (Control Module: General Memory Failure) - This Diagnostic Trouble Code (DTC) sets if the Power Steering Control Module (PSCM) detects an internal memory data error during the data plausibility check.
U3000:46 (Control Module: Calibration/Parameter Memory Failure) - This DTC sets if the PSCM detects an internal calibration data error during the data plausibility check.
U3000:49 (Control Module: Internal Electronic Failure) - If at any time during normal operation the PSCM detects an internal hardware error, DTC U3000:49 is set.
U3000:4B (Control Module: Over Temperature) - This DTC sets if the PSCM detects an internal over-temperature condition. Steering assist is reduced to protect the Electric Power-Assisted Steering (EPAS) electronics. Steering assist returns to the normal operating level when the system has cooled down.
U3000:53 (Control Module: Deactivated) - This DTC sets if the PSCM detects an internal error that causes a permanent de-activation which is not recoverable with an ignition cycle.
U3000:56 (Control Module: Invalid/Incomplete Configuration) - This DTC sets if the PSCM detects a mismatch of data structure in the non-volatile memory.
U3000:96 (Control Module: Component Internal Failure) - This DTC sets if a fault causes the EPAS to enter a failure mode.

⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC U3000 Ford?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for U3000 Ford Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the U3000 Ford code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the U3000 Ford Code Mean?

The Power Steering Control Module (PSCM) monitors various inputs and outputs of the Electric Power-Assisted Steering (EPAS) system in order to keep the system operating at peak capacity. Information provided by sensors (steering torque, vehicle speed, vehicle travel distance, etc.) are all compared to programmed and learned information. Likewise, outputs like the motor and steering rack (travel) are tested against programmed and learned information. The Diagnostic Trouble Code (DTC) will set when the PSCM detects a Control Module Failure Or Erratic.

U3000 Ford Code - Control Module Failure or Erratic

Need more Information on the Code?

Need more information on how to fix the U3000 Ford code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the U3000 Ford code diagnosed by a professional: Find a repair shop in your area