U2510 MERCURY - Received Data Does Not Match
U2510 MERCURY Possible Causes
- Powertrain Control Module (PCM) Calibration
- Transmission Control Module (TCM) Calibration
- Faulty Powertrain Control Module
- Faulty Transmission Control Module
How is the U2510 MERCURY code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the U2510 MERCURY code
Labor: 1.0The cost to diagnose the U2510 MERCURY code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
- Engine Light ON (or Service Engine Soon Warning Light)
U2510 MERCURY MeaningThe transceiver module communicates with the Passive Anti-Theft System (PATS) Key. The control functions are contained in the Powertrain Control Module (PCM). The PCM carries out all of the PATS functions such as receiving the identification code from the PATS key and controlling engine and transaxle enable. The PCM initiates the key interrogation sequence when the key is inserted in the ignition switch and when the ignition switch is turned to the RUN or START position. The Diagnostic Trouble Code (DTC) will set if the received data does not match what was expected.
More InformationNeed more information on how to fix the U2510 MERCURY code?
Get Access to Factory Service Manuals