U1950 MERCURY - UPB Communication Bus Fault
U1950 MERCURY Possible Causes
- UBP Bus wiring intermittently open/shorted to power or ground
- Faulty / intermittent electrical connection at any of the controllers on the UBP network
How is the U1950 MERCURY code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
It can occur if:
Wiring to the module becomes shorted by the module.
Wiring to the module becomes shorted between modules, such as where wires are routed on passenger side floor rails and become water soaked. Watch for water intrusion when this occurs.
What is the cost to diagnose the U1950 MERCURY code
Labor: 1.0The cost to diagnose the U1950 MERCURY code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
When is the code detected?When the controllers are unable to communicate with each other at any time while the ignition switch is turned to the “Run” position.
- Engine Light ON (or Service Engine Soon Warning Light)
- Engine won’t start – won’t crank
- ABS Warning Light ON
- Transmission may shift erratically
- Cluster won’t register any reading
U1950 MERCURY MeaningThe Anti-lock Brake System (ABS) module, the Powertrain Control Module (PCM), the Transmission Control Module (TCM), the instrument cluster and the parking aid module are just some of modules that communicate over the UART Based Protocol network bus or UBP Bus. This is a high-speed bus communication system and is not fault tolerant, which means any type of intermittent/loose connection between these 3 controllers will cause communication to stop. When the PCM, ABS module and instrument cluster are unable to communicate with each other at any time while the ignition switch is turned on, code U1950 will set.
More InformationNeed more information on how to fix the U1950 MERCURY code?
Get Access to Factory Service Manuals