U183B BUICK - Auxiliary Transmission Fluid Pump Control Module Lost Communication With Transmission Control Module
U183B BUICK Possible Causes
- Faulty Transmission Control Module (TCM)
- Transmission Control Module harness is open or shorted
- Transmission Control Module circuit poor electrical connection
How is the U183B BUICK code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the U183B BUICK code
Labor: 1.0The cost to diagnose the U183B BUICK code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
- Engine Light ON (or Service Engine Soon Warning Light)
U183B BUICK MeaningThe serial data circuit is the means by which the devices in the vehicle communicate with each other. Once the scan tool is connected to the serial data circuit through the Data Link Connector (DLC), the scan tool can be used to monitor each device for diagnostic purposes and to check for Diagnostic Trouble Code (DTC). When the vehicle is ON, each device communicating on the serial data circuit sends a state of health message to ensure that the device is operating properly. When a device stops communicating on the serial data circuit, for example, if the device loses power or ground, the state of health message it normally sends on the serial data circuit disappears. Other devices on the serial data circuit, which expect to receive that state of the health message, detect its absence; those devices in turn set a DTC associated with the loss of the state of health of the non-communicating device. A loss of serial data communications DTC does not represent a failure of the devices that contain the stored DTC. The DTC will set when a supervised periodic message that includes the transmitter device availability has not been received.
More InformationNeed more information on how to fix the U183B BUICK code?
Get Access to Factory Service Manuals