Engine-Codes - Buick - U180A Buick

U180A Buick Code - Electric A/C Compressor Control Module High Speed CAN Bus Off

- Code Popularity: 358 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC U180A Buick?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Electric A/C Compressor Control Module
  • Electric A/C Compressor Control Module harness is open or shorted
  • Electric A/C Compressor Control Module circuit poor electrical connection
⚠ Does your Buick have Safety Recalls? → Check here

How to Fix the DTC U180A Buick?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for U180A Buick Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the U180A Buick code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the U180A Buick Code Mean?

Modules connected to the Controller Area Network (CAN) serial data circuits monitor for serial data communications during normal vehicle operation. Operating information and commands are exchanged among the modules. The modules have prerecorded information about what messages are needed to be exchanged on the serial data circuits. The messages are supervised and also, some periodic messages are used by the receiver module as an availability indication of the transmitter module. Each message contains the identification number of the transmitter module. A module with a CAN serial data circuits malfunction or which loses power during the current ignition cycle will have a Loss of Communication Diagnostic Trouble Code (DTC) set by other modules that depend on information from that failed module. If any of the CAN circuit are shorted to battery voltage, ground, or between them no communication is possible on the CAN serial data bus, a Diagnostic Trouble Code will set.

U180A Buick Code - Electric A/C Compressor Control Module High Speed CAN Bus Off

Need more Information on the Code?

Need more information on how to fix the U180A Buick code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the U180A Buick code diagnosed by a professional: Find a repair shop in your area