U1467 DODGE - Implausible Driver Shift Request Signal Received On CAN And DPT CAN
U1467 DODGE Possible Causes
- Faulty Shifter
- Faulty Electronic Shift Module (ESM)
- Electronic Shift Module (ESM) harness is open or shorted
- Electronic Shift Module (ESM) circuit poor electrical connection
- Faulty Transmission Control Module (TCM)
How is the U1467 DODGE code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the U1467 DODGE code
Labor: 1.0The cost to diagnose the U1467 DODGE code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
- Engine Light ON (or Service Engine Soon Warning Light)
U1467 DODGE MeaningThe purpose of the diagnostic is to check the validity of the selected driving position. The driving position is received from two different Controller Area Network (CAN) BUS signals. If both signals are invalid because of any of the monitored CAN failures (time-out, checksum, alive counter, signal invalid) this fault is set to indicate that the driving position can not be determined. The failure is detected by the Transmission Control Module (TCM) if the CAN monitoring detects any failure on both driving position signals of the two CAN BUS signals.
More InformationNeed more information on how to fix the U1467 DODGE code?
Get Access to Factory Service Manuals