Engine-Codes - Dodge - U11D4 DODGE

U11D4 DODGE - Lost Pedal Position Message

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3  What is this?
Table of contents

U11D4 DODGE Possible Causes

  • Faulty Powertrain Control Module (PCM)
  • Faulty Transmission Control Module (TCM)

How is the U11D4 DODGE code repair?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

What is the cost to diagnose the U11D4 DODGE code

Labor: 1.0

The cost to diagnose the U11D4 DODGE code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much do you know about cars?

Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge

Play Now

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

U11D4 DODGE Meaning

This diagnostic checks the validity and availability of the gas pedal position signal which is sent by the Powertrain Control Module (PCM) via a CAN message. The diagnostic checks the validity by performing a CRC and message counter check to verify the gas pedal position signal is continuously updated by the PCM and that it has a valid value. The diagnostic also checks the availability by checking the received valid bit. A signal toggle bit and a signal parity bit are sent by the PCM within the CAN message. In order to be sure the message is continuously updated, the value of the toggle bit changes from 0 to 1 and vice versa every two messages. In order to be sure the message is valid, the parity bit value is set so that the sum of specific signals bits (the PDL_POS) of the message content plus the toggle bit plus the parity bit is an even number. If the toggle bit value does not change or the signal parity is not verified for a calibrated amount of time then the Diagnostic Trouble Code (DTC) U11D4 is set or when the signal is not available, the PCM sends a SNA default value to the TCM. If the TCM reads this value then DTC U11D4 is set.

More Information

Need more information on how to fix the U11D4 DODGE code?
Get Access to Factory Service Manuals

Need more help?

Get the U11d4 Dodge code diagnosed by a professional: Find a repair shop in your area