U11C7 JEEP - Lost Maximum Engine Torque Message
U11C7 JEEP Possible Causes
- Faulty Transmission Control Module (TCM)
- Transmission Control Module harness is open or shorted
- Transmission Control Module circuit poor electrical connection
How is the U11C7 JEEP code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the U11C7 JEEP code
Labor: 1.0The cost to diagnose the U11C7 JEEP code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
- Engine Light ON (or Service Engine Soon Warning Light)
U11C7 JEEP MeaningThis diagnostic determines the availability of the maximum indicated engine torque signal sent by the Powertrain Control Module (PCM) via a Controller Area Network (CAN) message. The diagnostic determines the availability by checking the valid bit. When the signal is not available, the PCM sends a Signal Not Available (SNA) default value to the Transmission Control Module (TCM). If the TCM reads this value then the Diagnostic Trouble Code (DTC) U11C7 is set.
More InformationNeed more information on how to fix the U11C7 JEEP code?
Get Access to Factory Service Manuals