Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.
The cost to diagnose the U11A0 RAM code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.
The pedestrian protection impact sensors perform their own self-test using power supplied by the Electronic Pedestrian Protection module (EPPM) then communicate this status back to the EPPM with periodic updates. The repair of this fault condition involves verifying the integrity of the wiring between the EPPM and the sensor.
This Diagnostic Trouble Code (DTC) sets when the EPPM no longer receives the notification of the status update from the Center Pedestrian Protection Satellite Acceleration Sensor. Once set, this DTC is latched for the entire ignition cycle. This code will set active if the loss of communication with the sensor has lasted for more then 2.5 seconds. This fault is latched for the full ignition cycle. The fault will go stored on the next key cycle upon the fault not setting for longer than 2.5 seconds.
Need more information on how to fix the U11A0 RAM code? Get Access to Factory Service Manuals
Get the U11A0 RAM code diagnosed by a professional: Find a repair shop in your area