U1197 DODGE - Security Seed Response Not Received From ECM/PCM
U1197 DODGE Possible Causes
- Powertrain Control Module (PCM) Programming
How is the U1197 DODGE code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the U1197 DODGE code
Labor: 1.0The cost to diagnose the U1197 DODGE code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
- Engine Light ON (or Service Engine Soon Warning Light)
U1197 DODGE MeaningWhenever the ignition is turned on or there is a remote start active, the Radio Frequency (RF) Hub performs a self-test and resynchronization routine. During the routine, the RF Hub interrogates the FOBIK for the secret key information and performs a Controller Area Network (CAN) Bus message handshake with the Powertrain Control Module (PCM) to start the vehicle. The PCM must reply to the RF Hub that the secret key information matches to initiate the start sequence or this code will set. The Diagnostic Trouble Code (DTC) sets whenever the RF Hub performs a handshake with the PCM and does not receive a security seed response from the PCM.
More InformationNeed more information on how to fix the U1197 DODGE code?
Get Access to Factory Service Manuals