U1193 JEEP - Lost Communication With Driver Side Blind Spot Sensor
U1193 JEEP Possible Causes
- Faulty Left Blind Spot Sensor (LBSS)
- Left Blind Spot Sensor harness is open or shorted
- Left Blind Spot Sensor circuit poor electrical connection
How is the U1193 JEEP code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the U1193 JEEP code
Labor: 1.0The cost to diagnose the U1193 JEEP code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
- Engine Light ON (or Service Engine Soon Warning Light)
U1193 JEEP MeaningThe Blind Spot Monitor (BSM) system used in this vehicle has two control modules. One control module is dedicated to each side of the vehicle. The blind spot modules are each integral to the blind spot sensor for the same side of the vehicle. If the sensor detects a vehicle in the blind spot path, the module will send a Controller Area Network (CAN) bussed message to the corresponding door module for a LED blind spot warning light request. The Diagnostic Trouble Code (DTC) sets when the Right Blind Spot Sensor (RBSS) does not receive messages from the Left Blind Spot Sensor (LBSS).
More InformationNeed more information on how to fix the U1193 JEEP code?
Get Access to Factory Service Manuals