Engine-Codes - Generic - U1162

U1162 Code - Lost Communications With Liftgate/Endgate Control Module

- Code Popularity: 8,108 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC U1162?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Liftgate/Endgate Control Module (LGM/EGM)
  • Liftgate/Endgate Control Module harness is open or shorted
  • Liftgate/Endgate Control Module circuit poor electrical connection
⚠ Does your Car have Safety Recalls? → Check here

How to Fix the DTC U1162?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for U1162 Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the U1162 code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the U1162 Code Mean?

Modules connected to the class 2 serial data circuit monitor for serial data communications during normal vehicle operation. Operating information and commands are exchanged among the modules. When a module receives a message for a critical operating parameter, the module records the identification number of the module which sent the message for the state of health monitoring/node alive messages. A critical operating parameter is one which, when not received, requires that the module use a default value for that parameter. Once an identification number is learned by a module, it will monitor for that module node alive message. Each module on the class 2 serial data circuit is required to send a Node Alive message every 2 seconds. When no message is detected from a learned identification number for 5 seconds, a Diagnostic Trouble Code (DTC) U1162 is set.

U1162 Code - Lost Communications With Liftgate/Endgate Control Module

Need more Information on the Code?

Need more information on how to fix the U1162 code? Get Access to Factory Service Manuals

Code U1162 Information for Specific Makes

  • U1162 Buick Lost Communications With Liftgate/Endgate Control Module
  • U1162 Cadillac Lost Communications With Liftgate/Endgate Control Module
  • U1162 Chevrolet Lost Communications With Liftgate/Endgate Control Module
  • U1162 GMC Lost Communications With Liftgate/Endgate Control Module

Need Help with the Code?

Get the U1162 code diagnosed by a professional: Find a repair shop in your area