Engine-Codes - Chrysler - U1110 CHRYSLER

U1110 CHRYSLER - Lost Vehicle Speed Message

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3  What is this?
Table of contents

U1110 CHRYSLER Possible Causes

  • Faulty Anti-lock Brake System (ABS) Module
  • Anti-lock Brake System Module harness is open or shorted
  • Anti-lock Brake System Module circuit poor electrical connection
  • Faulty Powertrain Control Module (PCM)

How is the U1110 CHRYSLER code repair?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Tech Notes

This is typically an electrical wiring connection issue at one of the controllers being monitored by the manufacturer.
It can occur if:
Someone changes a battery while the ignition switch is left on, that is, left in the RUN position.
Someone flashes/upgrades their engine controller – other modules unable to communicate with PCM during this process – this will set U1110 at a multitude of controllers on the vehicle – all false codes. Erase and carry on.
May need to disconnect both battery cables and touch them together for 15 seconds. Reattach battery cables, positive first, then negative and see if a soft reset helps.

What is the cost to diagnose the U1110 CHRYSLER code

Labor: 1.0

The cost to diagnose the U1110 CHRYSLER code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much do you know about cars?

Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge

Play Now

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Engine cranks but may not start – may be intermittent
  • May or may not be able to communicate with a scan tool / depends on problem

U1110 CHRYSLER Meaning

The Powertrain Control Module (PCM) receives the vehicle speed signal over the Controlled Area Network (CAN) C bus from the Anti-lock Brake Module. The Diagnostic Trouble Code (DTC) sets The PCM/ECM doesn't receive a vehicle speed signal from the Anti-Lock Brake Module over the CAN C bus.

More Information

Need more information on how to fix the U1110 CHRYSLER code?
Get Access to Factory Service Manuals

Need more help?

Get the U1110 Chrysler code diagnosed by a professional: Find a repair shop in your area