Engine-Codes - Nissan - U1001 2013 Nissan Rogue

U1001 2013 Nissan Rogue Code - Invalid or Missing Data for Primary Id

- Code Popularity: 3,480 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents

|What are the Possible Causes of the Code U1001 2013 Nissan Rogue?

  • Controller Area Network (CAN) communication harness is open or shorted
  • Faulty Engine Control Module (ECM)
  • Poor harness ground connection.

|How to Fix the U1001 2013 Nissan Rogue Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|Code U1001 2013 Nissan Rogue Tech Notes

Nissan has released service bulletins for this problem. A common cause with Nissan vehicles is the poor harness ground connection at the engine compartment and the ground connection behind the dash. Clean and resecure harness ground connection and reset engine light.

See U1000 code

|What is the Cost to Diagnose the Code U1001 2013 Nissan Rogue?

Labor: 1.0

The cost to diagnose the U1001 2013 Nissan Rogue code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

Does your Nissan have Safety Recalls? → Check here

|What are Code U1001 2013 Nissan Rogue Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|What Does the U1001 2013 Nissan Rogue Code Mean?

The Controller Area Network (CAN) is a serial communication line for real-time applications. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN H line, CAN L line) allowing a high rate of information transmission with less wiring.
Each control unit transmits/receives data but selectively reads the required data only.
The Diagnostic Trouble Code (DTC) sets when the Engine Control Module (ECM) is not transmitting or receiving CAN communication signals of OBD (emission-related diagnosis) for 2 seconds or more.

U1001 2013 Nissan Rogue Code - Invalid or Missing Data for Primary Id

|Need more Information on the U1001 2013 Nissan Rogue Code?

Need more information on how to fix the U1001 2013 Nissan Rogue code? Get Access to Factory Service Manuals

|Need Help with the U1001 2013 Nissan Rogue Code?

Get the U1001 2013 Nissan Rogue code diagnosed by a professional: Find a repair shop in your area