U1001 2011 NISSAN ROGUE - Invalid or Missing Data for Primary Id
U1001 2011 NISSAN ROGUE Possible Causes
- Controller Area Network (CAN) communication harness is open or shorted
- Faulty Engine Control Module (ECM)
- Poor harness ground connection.
How is the U1001 2011 NISSAN ROGUE code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
See U1000 code
What is the cost to diagnose the U1001 2011 NISSAN ROGUE code
Labor: 1.0The cost to diagnose the U1001 2011 NISSAN ROGUE code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
- Engine Light ON (or Service Engine Soon Warning Light)
U1001 2011 NISSAN ROGUE MeaningThe Controller Area Network (CAN) is a serial communication line for real-time applications. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN H line, CAN L line) allowing a high rate of information transmission with less wiring.
Each control unit transmits/receives data but selectively reads the required data only.
The Diagnostic Trouble Code (DTC) sets when the Engine Control Module (ECM) is not transmitting or receiving CAN communication signals of OBD (emission-related diagnosis) for 2 seconds or more.
More InformationNeed more information on how to fix the U1001 2011 NISSAN ROGUE code?
Get Access to Factory Service Manuals