Engine-Codes - Nissan - U1001 2010 Nissan Versa

U1001 2010 Nissan Versa Code - Invalid or Missing Data for Primary Id

- Code Popularity: 3,546 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC U1001 2010 Nissan Versa?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Controller Area Network (CAN) communication harness is open or shorted
  • Faulty Engine Control Module (ECM)
  • Poor harness ground connection.

Code Tech Notes

Nissan has released service bulletins for this problem see U1000 code. A common cause with Nissan vehicles is the poor harness ground connection at the engine compartment and the ground connection behind the dash. Clean and resecure harness ground connection and reset engine light.

⚠ Does your Nissan have Safety Recalls? → Check here

How to Fix the DTC U1001 2010 Nissan Versa?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for U1001 2010 Nissan Versa Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the U1001 2010 Nissan Versa code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the U1001 2010 Nissan Versa Code Mean?

The Controller Area Network (CAN) is a serial communication line for real-time applications. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN H line, CAN L line) allowing a high rate of information transmission with less wiring.
Each control unit transmits/receives data but selectively reads the required data only.
The Diagnostic Trouble Code (DTC) sets when the Engine Control Module (ECM) is not transmitting or receiving CAN communication signals of OBD (emission-related diagnosis) for 2 seconds or more.

U1001 2010 Nissan Versa Code - Invalid or Missing Data for Primary Id

Need more Information on the Code?

Need more information on how to fix the U1001 2010 Nissan Versa code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the U1001 2010 Nissan Versa code diagnosed by a professional: Find a repair shop in your area