U1000 2008 NISSAN VERSA Code - CAN Communication Line - Signal Malfunction
|U1000 2008 NISSAN VERSA code possible causes
- Controller Area Network (CAN) communication harness is open or shorted
- Faulty Engine Control Module (ECM)
- Poor harness ground connection.
|How is the U1000 2008 NISSAN VERSA code repair?
Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|U1000 2008 NISSAN VERSA code tech notes
There is a service bulletin for the 2008 Nissan Versa:
2008 Nissan Versa Factory Service Bulletin OBDII Code U1000
Usually, the problem is poor harness ground connection. The service bulletin suggests cleaning engine and body harness ground connection to repair the problem. Loosen the ground connectors clean them with sandpaper on the connector side and body side and retighten the bolts back.
|What is the cost to diagnose the U1000 2008 NISSAN VERSA code
The cost to diagnose the U1000 2008 NISSAN VERSA code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|What are U1000 2008 NISSAN VERSA code possible symptoms?
- Engine Light ON (or Service Engine Soon Warning Light)
|What is U1000 2008 NISSAN VERSA code meaning?
The Controller Area Network (CAN) is a serial communication line for real-time applications. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN H line, CAN L line) allowing a high rate of information transmission with less wiring.
Each control unit transmits/receives data but selectively reads the required data only.
The Diagnostic Trouble Code (DTC) sets when the Engine Control Module (ECM
) is not transmitting or receiving CAN communication signals of OBD (emission-related diagnosis) for 2 seconds or more.