Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
The cost to diagnose the P2610 2010 TOYOTA CAMRY code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
5 hours after the ignition switch is turned OFF, the soak timer activates the Engine Control Module (ECM) to begin the EVAP system monitor. While the engine is running, the ECM monitors the synchronization of the soak timer and the CPU clock. If these two are not synchronized, the ECM interprets this as a malfunction, illuminates the MIL and sets the Diagnostic Trouble Code (DTC).
Need more information on how to fix the P2610 2010 TOYOTA CAMRY code?
Get Access to Factory Service Manuals
Get the P2610 2010 Toyota Camry code diagnosed by a professional: Find a repair shop in your area