P2419 2010 TOYOTA CAMRY - Evaporative Emission System Switching Valve Control Circuit Low
P2419 2010 TOYOTA CAMRY Possible Causes
- Faulty Vacuum Pump Module
- Vacuum Pump Module harness is open or shorted
- Vacuum Pump Module circuit poor electrical connection.
- Faulty Engine Control Module (ECM)
How is the P2419 2010 TOYOTA CAMRY code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the P2419 2010 TOYOTA CAMRY code
Labor: 1.0The cost to diagnose the P2419 2010 TOYOTA CAMRY code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
When is the code detected?To determine leak criterion (Reference pressure), vacuum pump creates negative pressure in canister pump module through 0.02 inch orifice and pressure is measured. If the conditions are not met, Engine Control Module (ECM) the code will be set.
- Engine Light ON (or Service Engine Soon Warning Light)
P2419 2010 TOYOTA CAMRY Meaning5 hours after the ignition switch is turned OFF, the leak detection pump creates negative pressure(vacuum) in the EVAP system. The Engine Control Module (ECM) monitors for leaks and actuator malfunctions based on the EVAP pressure. HINT: If the engine coolant temperature is not below 35°C (95°F) 5 hours after the ignition switch is turned OFF, the monitor check starts 2 hours later. If it is still not below 35°C (95°F) 7 hours after the ignition switch is turned OFF, the monitor check starts 2.5 hours later.
More InformationNeed more information on how to fix the P2419 2010 TOYOTA CAMRY code?
Get Access to Factory Service Manuals