⚠ Does your Toyota have Safety Recalls? → Check here
How to Fix the DTC P2419 2008 Toyota Prius?
Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.
Search for P2419 2008 Toyota Prius Questions and Answers: Search here →
What is the Cost to Diagnose the Code?
Labor: 1.0
The cost to diagnose the P2419 2008 Toyota Prius code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.
What are Code Possible Symptoms?
Engine Light ON (or Service Engine Soon Warning Light)
What Does the P2419 2008 Toyota Prius Code Mean?
When 5 hours have elapsed after the ignition switch is turned OFF, the electric vacuum pump creates negative pressure (vacuum) in Evaporative Emission (EVAP) system. Then Engine Control Module (ECM) monitors for leaks and actuator malfunctions based on EVAP pressure. The ECM determines that the vent valve is stuck ON (closed) if 1) the pressure is higher than -7.5 mmHg (-1 kPa) or lower than -33.75 mmHg (-4.5 kPa), and 2) the EVAP system pressure does not stabilize for a duration of 60 seconds. The ECM illuminates the MIL and sets a Diagnostic Trouble Code (DTC).
P2419 2008 Toyota Prius Code - Evaporative Emission System Switching Valve Control Circuit Low