Engine-Codes - Toyota - P2252 2004 TOYOTA PRIUS

P2252 2004 TOYOTA PRIUS Code - Oxygen A/F Sensor Reference Ground Circuit Low Bank 1 Sensor 1

Repair Importance Level: 2/3
Repair Difficulty Level: 2/3  What is this?
Table of contents

|P2252 2004 TOYOTA PRIUS code possible causes

  • Faulty Air/Fuel Sensor Bank 2
  • Air/Fuel Sensor Bank 2 harness is open or shorted
  • Air/Fuel Sensor Bank 2 circuit poor electrical connection
  • Air/Fuel Sensor Relay
  • Faulty Engine Control Module (ECM)

|How is the P2252 2004 TOYOTA PRIUS code repair?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|What is the cost to diagnose the P2252 2004 TOYOTA PRIUS code

Labor: 1.0

The cost to diagnose the P2252 2004 TOYOTA PRIUS code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are P2252 2004 TOYOTA PRIUS code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|What is P2252 2004 TOYOTA PRIUS code meaning?

The Air-Fuel ratio (A/F) sensor provides output voltage approximately equal to the existing air-fuel ratio.
The A/F sensor output voltage is used to provide feedback for the Engine Control Module (ECM) to control the air-fuel ratio.
With the A/F sensor output, the ECM can determine deviation from the stoichiometric air-fuel ratio and control proper injection time. If the A/F sensor is malfunctioning, the ECM is unable to accurately control air-fuel ratio.
The A/F sensor is equipped with a heater which heats the zirconia element. The heater is also controlled by the ECM. When the intake air volume is low (the temperature of the exhaust gas is low), current flows to the heater which heats the sensor to facilitate detection of accurate oxygen concentration.
The A/F sensor is a planar type. Compared to a conventional type, the sensor and heater portions are narrower. Because the heat of the heater is conducted through the alumina to zirconia (of the sensor portion), sensor activation is accelerated.

The code is output when there is an open or short in the A/F sensor circuit, or if A/F sensor output drops. To detect these problems, the voltage of the A/F sensor is monitored when turning the ignition switch to the ON position, and the admittance (admittance is an electrical term that indicates the ease of flow of current) is checked while driving. If the voltage of the A/F sensor is between 0.6 V and 4.5 V, it is considered normal. If the voltage is outside of the specified range, or the admittance is less than the standard value, the ECM will determine that there is a malfunction in the A/F sensor. If the same malfunction is detected in the next driving cycle, the MIL is illuminated and a DTC is set.

|Need more information with the P2252 2004 TOYOTA PRIUS code?

Need more information on how to fix the P2252 2004 TOYOTA PRIUS code?
Get Access to Factory Service Manuals

|Need help with a P2252 2004 TOYOTA PRIUS code?

Get the P2252 2004 Toyota Prius code diagnosed by a professional: Find a repair shop in your area