P2198 Mercury Code - Oxygen Sensor Signal Biased/Stuck Rich Bank 2 Sensor 1
Quick Answer
The P2198 code for a Mercury vehicle indicates that the Oxygen Sensor Signal is Biased/Stuck Rich on Bank 2 Sensor 1. Common causes include Faulty oxygen sensor, Damaged wiring harness or connector, Vacuum leak. Severity is Moderate - service should be scheduled soon. The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.
- What it means
- P2198 Mercury indicates Oxygen Sensor Signal Biased/Stuck Rich Bank 2 Sensor 1.
- Common causes
- Common causes include Faulty oxygen sensor, Damaged wiring harness or connector, Vacuum leak.
- Severity
- Moderate - service should be scheduled soon.
- Can I drive?
- The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
Code P2198 Mercury Description
The P2198 code for a Mercury vehicle indicates that the Oxygen Sensor Signal is Biased/Stuck Rich on Bank 2 Sensor 1. This means that the oxygen sensor located in the exhaust system before the catalytic converter on the second bank of cylinders is sending a signal that indicates a rich air-fuel mixture. The oxygen sensor plays a crucial role in monitoring the oxygen levels in the exhaust gases, which helps the engine control module (ECM) adjust the air-fuel ratio for optimal fuel efficiency and emissions control.
Common Causes of P2198 Mercury
- Faulty oxygen sensor
- Damaged wiring harness or connector
- Vacuum leak
- Fuel pressure regulator problem
- Fuel injector issue
Symptoms of P2198 Mercury
- Decreased fuel efficiency
- Rough idling or stalling
- Hesitation during acceleration
- Check Engine Light illuminated
- Increased emissions
How to Fix P2198 Mercury
- Begin by diagnosing the specific cause of the rich signal using a scan tool to read live data and pinpoint the issue.
- Inspect the oxygen sensor on Bank 2 Sensor 1 for any damage or contamination and replace if necessary.
- Check the wiring harness and connector for any signs of damage or corrosion and repair or replace as needed.
- Test the fuel pressure regulator for proper operation and replace if faulty.
- Inspect the fuel injectors on Bank 2 for any clogs or malfunctions and clean or replace as necessary.
Cost to Fix P2198 Mercury
The typical repair costs for addressing a P2198 code on a Mercury vehicle can range from $200 to $500, including parts and labor. However, it's important to note that the specific diagnosis time and labor rates at auto repair shops can vary based on factors such as location, vehicle make and model, and engine type. Most auto repair shops charge between $80 and $150 per hour for labor, but rates may be higher in metropolitan areas or at dealerships and lower at independent shops. It's recommended to consult local rates for a more accurate estimate.
Tech Notes for P2198 Mercury
2010-2011 Mercury Milan
2009-2011 Mercury Mariner
Mercury Factory Service Bulletin OBDII Code P2198
Need more information about the P2198 Mercury code?
Need more information on how to fix the P2198 Mercury code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P2198 Mercury code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P2198 Mercury Code
No Frequently Asked Questions about P2198 Mercury Code found.
Discuss the causes and fixes for P2198 Mercury OBDII Code
Code P2198 Mercury comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.