|How is the P2138 2006 FORD FUSION code repair?
Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|What is the cost to diagnose the P2138 2006 FORD FUSION code
The cost to diagnose the P2138 2006 FORD FUSION code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|What is P2138 2006 FORD FUSION code meaning?
The Accelerator Pedal Position (APP) sensor is an input to the Powertrain Control Module (PCM
) and used to determine the amount of torque requested by the operator. There are 2 pedal position signals in the sensor. Both signals, APP and APP2, have a positive slope (increasing angle, increasing voltage), but are offset and increase at different rates. The 2 pedal position signals make sure the PCM
receives a correct input even if 1 signal has a concern. The PCM
determines if a signal is incorrect by calculating where it should be, inferred from the other signals. If a concern is present with one of the circuits the other input is used. There are 2 reference voltage circuits, 2 signal return circuits, and 2 signal circuits (a total of 6 circuits and pins) between the PCM
and the APP sensor assembly. The pedal position signal is converted to pedal travel degrees (rotary angle) by the PCM
. The software converts these degrees to counts, which is the input to the torque based strategy. If the APP sensor inputs APP1 and APP2 disagree on the position of the accelerator pedal by more than an expected value, the P2138 is set.