P2128 2016 Toyota RAV4 Code - Throttle Pedal Position Sensor/Switch 'E' Circuit Input High

The common symptoms of code P2128 include issues with acceleration, reduced engine power, and the vehicle going into limp mode.

The code P2128 indicates that the throttle pedal position sensor/switch 'E' circuit is detecting a high input signal, which may point to a problem with the sensor or its circuit.

Possible causes of code P2128 include a faulty throttle pedal position sensor, damaged wiring or connectors in the sensor circuit, or a malfunctioning electronic throttle control system.

To diagnose code P2128, you can use an OBDII scanner to retrieve the code and then inspect the throttle pedal position sensor, its wiring, and connectors for any signs of damage or wear.

It is not recommended to drive your vehicle with code P2128 as it can lead to performance issues and potential safety hazards. It is best to address the issue promptly.

Repairing code P2128 involves replacing the faulty throttle pedal position sensor, repairing any damaged wiring or connectors, and clearing the code with an OBDII scanner.

While you can clear the code temporarily, it is important to address the root cause of code P2128 to prevent the issue from recurring and potentially causing further damage.

Extreme weather conditions such as excessive heat or cold can sometimes affect the performance of sensors and circuits, potentially leading to the triggering of code P2128.

The cost of fixing code P2128 can vary depending on the extent of the issue and whether any parts need to be replaced. Generally, the repair cost can range from $100 to $300.

Regular maintenance, such as checking and cleaning throttle components, inspecting wiring for damage, and addressing any issues promptly, can help prevent the occurrence of code P2128 in your Toyota RAV4.