P2128 2008 NISSAN ROGUE - Accelerator Pedal Position Sensor Circuit
P2128 2008 NISSAN ROGUE Possible Causes
- Faulty Accelerator Pedal Position (APP) Sensor
- Accelerator Pedal Position (APP) Sensor harness is open or shorted
- Accelerator Pedal Position (APP) Sensor circuit poor electrical connection
- Faulty Engine Control Module (ECM)
- Electric Throttle Control Actuator(Throttle Body)
How is the P2128 2008 NISSAN ROGUE code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the P2128 2008 NISSAN ROGUE code
Labor: 1.0The cost to diagnose the P2128 2008 NISSAN ROGUE code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
When is the code detected?An excessively low voltage from the APP sensor 2 is sent to ECM.
- Engine Light ON (or Service Engine Soon Warning Light)
P2128 2008 NISSAN ROGUE MeaningThe Accelerator Pedal Position (APP) sensor is installed on the upper end of the accelerator pedal assembly. The sensor detects the accelerator position and sends a signal to the Engine Control Module (ECM). Accelerator pedal position sensor has two sensors. These sensors are a kind of potentiometers which transform the accelerator pedal position into an output voltage and emit the voltage signal to the ECM. In addition, these sensors detect the opening and closing speed of the accelerator pedal and feed the voltage signals to the ECM. The ECM judges the current opening angle of the accelerator pedal from these signals and controls the throttle control motor based on these signals. Idle position of the accelerator pedal is determined by the ECM receiving the signal from the accelerator pedal position sensor. The ECM uses this signal for the engine operation such as fuel cut.
More InformationNeed more information on how to fix the P2128 2008 NISSAN ROGUE code?
Get Access to Factory Service Manuals