P2126 2006 FORD FUSION - Throttle/Pedal Position Sensor/Switch 'E' Circuit Range/Performance
P2126 2006 FORD FUSION Possible Causes
- Faulty Accelerator Pedal Position (APP) Sensor
- Accelerator Pedal Position (APP) Sensor harness is open or shorted
- Accelerator Pedal Position (APP) Sensor circuit poor electrical connection
- Faulty Powertrain Control Module (PCM)
How is the P2126 2006 FORD FUSION code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the P2126 2006 FORD FUSION code
Labor: 1.0The cost to diagnose the P2126 2006 FORD FUSION code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
- Engine Light ON (or Service Engine Soon Warning Light)
- No throttle pedal response
P2126 2006 FORD FUSION MeaningThe Accelerator Pedal Position (APP) sensor is an input to the Powertrain Control Module (PCM) and used to determine the amount of torque requested by the operator. There are 2 pedal position signals in the sensor. Both signals, APP and APP2, have a positive slope (increasing angle, increasing voltage), but are offset and increase at different rates. The 2 pedal position signals make sure the PCM receives a correct input even if 1 signal has a concern. The PCM determines if a signal is incorrect by calculating where it should be, inferred from the other signals. If a concern is present with one of the circuits the other input is used. There are 2 reference voltage circuits, 2 signal return circuits, and 2 signal circuits (a total of 6 circuits and pins) between the PCM and the APP sensor assembly. The pedal position signal is converted to pedal travel degrees (rotary angle) by the PCM. The software converts these degrees to counts, which is the input to the torque based strategy. The accelerator pedal position (APP) sensor fault flag is set for sensor 2 by the PCM, indicating the signal is out of the normal self-test operating range
More InformationNeed more information on how to fix the P2126 2006 FORD FUSION code?
Get Access to Factory Service Manuals