Engine-Codes - Nissan - P2123 2008 NISSAN ROGUE

P2123 2008 NISSAN ROGUE - Accelerator Pedal Position Sensor Circuit Range/Performance

Repair Importance Level: 3/3
Repair Difficulty Level: 2/3  What is this?
Table of contents

P2123 2008 NISSAN ROGUE Possible Causes

  • Faulty Accelerator Pedal Position Sensor
  • Accelerator Pedal Position Sensor harness is open or shorted
  • Accelerator Pedal Position Sensor circuit poor electrical connection

How is the P2123 2008 NISSAN ROGUE code repair?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

What is the cost to diagnose the P2123 2008 NISSAN ROGUE code

Labor: 1.0

The cost to diagnose the P2123 2008 NISSAN ROGUE code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much do you know about cars?

Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge

Play Now

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)
  • No Accelerator Pedal respsonse

P2123 2008 NISSAN ROGUE Meaning

The Accelerator Pedal Position (APP) sensor is installed on the upper end of the accelerator pedal assembly. The sensor detects the accelerator position and sends a signal to the Engine Control Module (ECM).
Accelerator pedal position sensor has two sensors. These sensors are a kind of potentiometers which transform the accelerator pedal position into output voltage, and emit the voltage signal to the ECM.
In addition, these sensors detect the opening and closing speed of the accelerator pedal and feed the voltage signals to the ECM. The ECM judges the current opening angle of the accelerator pedal from these signals and controls the throttle control motor based on these signals.
Idle position of the accelerator pedal is determined by the ECM receiving the signal from the accelerator pedal position sensor. The ECM uses this signal for the engine operation
such as fuel cut.

More Information

Need more information on how to fix the P2123 2008 NISSAN ROGUE code?
Get Access to Factory Service Manuals

Need more help?

Get the P2123 2008 Nissan Rogue code diagnosed by a professional: Find a repair shop in your area