Engine-Codes - Ford - P2110 2006 Ford Fusion

P2110 2006 Ford Fusion Code - Throttle Actuator Control System - Forced Limited RPM

- Code Popularity: 8,159 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P2110 2006 Ford Fusion?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Throttle Actuator Control (TAC) Motor
  • Throttle Actuator Control (TAC) Motor harness is open or shorted
  • Throttle Actuator Control (TAC) Motor circuit poor electrical connection
  • Faulty Powertrain Control Module (PCM)
⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC P2110 2006 Ford Fusion?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P2110 2006 Ford Fusion Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P2110 2006 Ford Fusion code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light

What Does the P2110 2006 Ford Fusion Code Mean?

The electronic Throttle Actuator Control (TAC) is a DC motor controlled by the Powertrain Control Module (PCM). There are 2 designs for the TAC, parallel and inline. The parallel design has the motor under the bore parallel to the plate shaft. The motor housing is integrated into the main housing. The inline design has a separate motor housing. An internal spring is used in both designs to return the throttle plate to a default position. The default position is typically a throttle angle of 7 to 8 degrees from the hard stop angle. The closed throttle plate hard stop prevents the throttle from binding in the bore. This hard stop setting is not adjustable and is set to result in less airflow than the minimum engine airflow required at idle. The P2110 code is set when the Throttle Actuator Control (TAC) system is in the Failure Mode Effects Management (FMEM) mode of forced limited RPM.

P2110 2006 Ford Fusion Code - Throttle Actuator Control System - Forced Limited RPM

Need more Information on the Code?

Need more information on how to fix the P2110 2006 Ford Fusion code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P2110 2006 Ford Fusion code diagnosed by a professional: Find a repair shop in your area