P2105 Mercury Code - Throttle Actuator Control System - Forced Engine Shutdown
Quick Answer
The P2105 diagnostic trouble code (DTC) for Mercury vehicles refers to the Throttle Actuator Control System - Forced Engine Shutdown. Common causes include Faulty throttle position sensor, Carbon buildup in the throttle body, Wiring or connection issues in the throttle actuator control system. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
- What it means
- P2105 Mercury indicates Throttle Actuator Control System - Forced Engine Shutdown.
- Common causes
- Common causes include Faulty throttle position sensor, Carbon buildup in the throttle body, Wiring or connection issues in the throttle actuator control system.
- Severity
- High - diagnose this code as soon as possible.
- Can I drive?
- Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
Code P2105 Mercury Description
The P2105 diagnostic trouble code (DTC) for Mercury vehicles refers to the Throttle Actuator Control System - Forced Engine Shutdown. This code indicates a problem with the throttle actuator control system, which is responsible for managing the throttle opening in response to driver input. In the event of a forced engine shutdown, the vehicle's onboard computer (ECU) has detected a fault that could potentially lead to unsafe driving conditions or engine damage, prompting it to shut down the engine to prevent further harm.
Common Causes of P2105 Mercury
- Faulty throttle position sensor
- Carbon buildup in the throttle body
- Wiring or connection issues in the throttle actuator control system
- Electronic throttle control module failure
- Software glitch in the ECU
Symptoms of P2105 Mercury
- Reduced engine power
- Engine stalling or rough idling
- Illumination of the Check Engine Light
- Vehicle going into limp mode
- Difficulty accelerating or maintaining speed
How to Fix P2105 Mercury
- Perform a thorough inspection of the throttle actuator control system components.
- Clean the throttle body to remove any carbon buildup.
- Test the throttle position sensor for proper operation and replace if necessary.
- Check and repair any wiring or connection issues in the throttle actuator control system.
- Reprogram or replace the electronic throttle control module if needed.
Cost to Fix P2105 Mercury
The cost of repairing a P2105 code on a Mercury vehicle can vary depending on the specific issue and the labor rates in your area. On average, the repair cost for this issue can range from $200 to $500, including parts and labor. However, it's important to note that diagnosis time and labor rates at auto repair shops can vary, so it's recommended to check with local shops for a more accurate estimate. Keep in mind that rates at dealerships or in metropolitan areas may be higher, while independent shops may offer more competitive pricing.
Tech Notes for P2105 Mercury
Need more information about the P2105 Mercury code?
Need more information on how to fix the P2105 Mercury code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P2105 Mercury code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P2105 Mercury Code
No Frequently Asked Questions about P2105 Mercury Code found.
Discuss the causes and fixes for P2105 Mercury OBDII Code
Code P2105 Mercury comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.