Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
The P2105 code is an informational code and may be set in combination with a number of other codes which are causing the FMEM. Diagnose other codes first.
The cost to diagnose the P2105 2006 FORD FUSION code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
The electronic Throttle Actuator Control (TAC) is a DC motor controlled by the Powertrain Control Module (PCM). There are 2 designs for the TAC, parallel and inline. The parallel design has the motor under the bore parallel to the plate shaft. The motor housing is integrated into the main housing. The inline design has a separate motor housing. An internal spring is used in both designs to return the throttle plate to a default position. The default position is typically a throttle angle of 7 to 8 degrees from the hard stop angle. The closed throttle plate hard stop prevents the throttle from binding in the bore. This hard stop setting is not adjustable and is set to result in less airflow than the minimum engine airflow required at idle. The P2105 code is set when the Throttle Actuator Control (TAC) system is in the Failure Mode Effects Management (FMEM) mode of forced engine shutdown.
Need more information on how to fix the P2105 2006 FORD FUSION code?
Get Access to Factory Service Manuals
Get the P2105 2006 Ford Fusion code diagnosed by a professional: Find a repair shop in your area