Engine-Codes - Ford - P2101 2012 Ford Fusion

P2101 2012 Ford Fusion Code - Throttle Actuator Control Motor Circuit Range/Performance

- Code Popularity: 2,994 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P2101 2012 Ford Fusion?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Throttle Actuator Control Motor
  • Throttle Actuator Control Motor harness is open
  • Throttle Actuator Control Motor circuit poor electrical connection
⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC P2101 2012 Ford Fusion?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P2101 2012 Ford Fusion Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P2101 2012 Ford Fusion code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

When is the Code Detected?

A powertrain control module (PCM) fault flag is set indicating the motor circuit is open, and may require cycling the key.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the P2101 2012 Ford Fusion Code Mean?

The electronic Throttle Actuator Control (TAC) is a DC motor controlled by the Powertrain Control Module (PCM). There are 2 designs for the TAC, parallel and inline. The parallel design has the motor under the bore parallel to the plate shaft. The motor housing is integrated into the main housing. The inline design has a separate motor housing. An internal spring is used in both designs to return the throttle plate to a default position. The default position is typically a throttle angle of 7 to 8 degrees from the hard stop angle. The closed throttle plate hard stop prevents the throttle from binding in the bore. This hard stop setting is not adjustable and is set to result in less airflow than the minimum engine airflow required at idle.

P2101 2012 Ford Fusion Code - Throttle Actuator Control Motor Circuit Range/Performance

Need more Information on the Code?

Need more information on how to fix the P2101 2012 Ford Fusion code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P2101 2012 Ford Fusion code diagnosed by a professional: Find a repair shop in your area