P2101 2008 NISSAN ROGUE - Electric Throttle Control Performance
P2101 2008 NISSAN ROGUE Possible Causes
- Faulty Electric Throttle Control (ETC) Actuator
- Electric Throttle Control (ETC) Actuator harness is open or shorted
- Electric Throttle Control (ETC) Actuator circuit poor electrical connection
How is the P2101 2008 NISSAN ROGUE code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the P2101 2008 NISSAN ROGUE code
Labor: 1.0The cost to diagnose the P2101 2008 NISSAN ROGUE code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
When is the code detected?Electric throttle control function does not operate properly.
- Engine Light ON (or Service Engine Soon Warning Light)
P2101 2008 NISSAN ROGUE MeaningThe throttle actuator is operated by the Engine Control Module (ECM) and it opens and closes the throttle valve. Power supply for the throttle control motor is provided to the ECM via throttle control motor relay. The throttle control motor relay is ON/OFF controlled by the ECM. When the ignition switch is turned ON, the ECM sends an ON signal to throttle control motor relay and battery voltage is provided to the ECM. When the ignition switch is turned OFF, the ECM sends an OFF signal to throttle control motor relay and battery voltage is not provided to the ECM. The opening angle of the throttle valve is detected by the throttle position sensor which is mounted on the throttle body. The throttle position sensor provides feedback to the ECM. This feedback allows the ECM to control the throttle actuator and monitor the throttle opening angle in response to driver inputs.
More InformationNeed more information on how to fix the P2101 2008 NISSAN ROGUE code?
Get Access to Factory Service Manuals