Engine-Codes - Ford - P1516 Ford

P1516 Ford Code - Intake Manifold Runner Control Input Error Bank 1

- Code Popularity: 18,719 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P1516 Ford?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Intake Manifold Runner Control (IMRC) actuator
  • Intake Manifold Runner Control actuator harness is open or shorted
  • Intake Manifold Runner Control actuator circuit poor electrical connection
  • Faulty Powertrain Control Module (PCM)
⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC P1516 Ford?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P1516 Ford Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P1516 Ford code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the P1516 Ford Code Mean?

The Intake Manifold Runner Control (IMRC) is an electrically actuated system consisting of a motorized actuator with an attaching linkage for each housing on each bank. The linkage attaches to the housing butterfly plate levers. Each IMRC housing is an aluminum casting with two intake air passages for each cylinder. One passage is always open, and the other is opened and closed with a butterfly valve plate. The housing uses a return spring to hold the plates closed. The motorized actuator houses internal switches to provide feedback to the Powertrain Control Module (PCM), indicating linkage and plate position. Under about 3000 rpm, the vacuum solenoid will be energized. This will allow the manifold vacuum to be applied and the butterfly valve plates to stay closed. Above approximately 3000 rpm, the vacuum solenoid will be de-energized. This will allow a vacuum to vent from the actuator and the butterfly valve plates to open. The Diagnostic Trouble Code (DTC) sets when the signal is outside an expected calibrated range.

P1516 Ford Code - Intake Manifold Runner Control Input Error Bank 1

Need more Information on the Code?

Need more information on how to fix the P1516 Ford code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P1516 Ford code diagnosed by a professional: Find a repair shop in your area