Engine-Codes - Buick - P1514 BUICK

P1514 BUICK - Throttle Actuator Control System Mass Air Flow Performance

Repair Importance Level: 3/3
Repair Difficulty Level: 2/3  What is this?
Table of contents

P1514 BUICK Possible Causes

  • Faulty Throttle Actuator Control (TAC)
  • Throttle Actuator Control (TAC) harness is open or shorted
  • Throttle Actuator Control (TAC) circuit poor electrical connection
  • Faulty Mass Air Flow (MAF) Sensor

How is the P1514 BUICK code repair?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

What is the cost to diagnose the P1514 BUICK code

Labor: 1.0

The cost to diagnose the P1514 BUICK code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
How much do you know about cars?

Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge

Play Now

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

P1514 BUICK Meaning

The Throttle Actuator Control (TAC) system uses vehicle electronics and components to calculate and control the position of the throttle blade. This eliminates the need for a mechanical cable attachment from the accelerator pedal to the throttle body. This system also performs the cruise control functions as well.
The TAC system components include, but are not limited to the following:
- The accelerator pedal position (APP) sensors
- The throttle body
- The powertrain control module (PCM)
Each of these components interface together to ensure accurate calculations and control of the throttle position (TP).
<b>Throttle Body Assembly</b>
The throttle body for the throttle actuator control (TAC) system is similar to a conventional throttle body with several exceptions. One exception being the use of a motor to control the throttle position instead of a mechanical cable. Another exception is the throttle position (TP) sensor. The TP sensor is mounted in the throttle body assembly. The TP sensor is 2 individual TP sensors within the throttle body assembly. Two separate signal, low reference, and 5-volt reference circuits are used to connect the TP sensors and the powertrain control module (PCM). TP sensor 2 signal voltage increases as the throttle opens. TP sensor 1 signal voltage decreases as the throttle opens.

More Information

Need more information on how to fix the P1514 BUICK code?
Get Access to Factory Service Manuals

Need more help?

Get the P1514 Buick code diagnosed by a professional: Find a repair shop in your area