P1452 2008 TOYOTA PRIUS - Fuel Tank Pressure Sensor Low Input
P1452 2008 TOYOTA PRIUS Possible Causes
- Faulty Fuel Tank Pressure (FTP)
- Fuel Tank Pressure harness is open or shorted
- Fuel Tank Pressure circuit poor electrical connection
- Engine Control Module (ECM)
How is the P1452 2008 TOYOTA PRIUS code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the P1452 2008 TOYOTA PRIUS code
Labor: 1.0The cost to diagnose the P1452 2008 TOYOTA PRIUS code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
- Engine Light ON (or Service Engine Soon Warning Light)
P1452 2008 TOYOTA PRIUS MeaningWhile the engine is running, if a predetermined condition (closed loop, etc.) is met, the purge VSV is opened by the Engine Control Module (ECM) and stored fuel vapors in the canister are purged to the intake manifold. The ECM changes the duty cycle ratio of the purge VSV to control purge flow volume. The purge flow volume is also determined by the intake manifold pressure. Atmospheric pressure is allowed into the canister through the vent valve to ensure that the purge flow is maintained when the negative pressure (vacuum) is applied to the canister.
This monitor checks for Evaporative Emission (EVAP) system leaks and canister pump module malfunctions. The monitor starts 5 hours after the power switch is turned OFF. More than 5 hours are required to allow the fuel to cool down to stabilize the Fuel Tank Pressure (FTP), thus making the EVAP system monitor more accurateThe leak detection pump creates negative pressure (vacuum) in the EVAP system and the pressure is measured. Finally, the ECM monitors for leaks from the EVAP system and malfunctions in both the canister pump module and purge VSV, based on the EVAP pressure.
More InformationNeed more information on how to fix the P1452 2008 TOYOTA PRIUS code?
Get Access to Factory Service Manuals