P1451 2010 FORD FUSION - EVAP Control System Canister Vent Solenoid Circuit Malfunction
P1451 2010 FORD FUSION Possible Causes
- Faulty Canister Vent Solenoid
- Canister Vent Solenoid harness is open or shorted
- Canister Vent Solenoid electrical circuit poor connection
- Faulty Powertrain Control Module (PCM)
How is the P1451 2010 FORD FUSION code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the P1451 2010 FORD FUSION code
Labor: 1.0The cost to diagnose the P1451 2010 FORD FUSION code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
When is the code detected?The code indicates that an Evaporative Emission (EVAP) system leak has been detected.
- Engine Light ON (or Service Engine Soon Warning Light)
P1451 2010 FORD FUSION MeaningThe Powertrain Control Module (PCM) monitors the Canister Vent (CV) solenoid circuit for an electrical failure. The test fails when the signal moves outside the minimum or maximum allowable calibrated parameters for a specified canister vent duty cycle by PCM command.
More InformationNeed more information on how to fix the P1451 2010 FORD FUSION code?
Get Access to Factory Service Manuals