Engine-Codes - Mercury - P1436 Mercury

P1436 Mercury Code - A/C Evaporator Air Temperature Circuit Low

- Code Popularity: 1,146 Views
- Repair Importance Level: 1/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P1436 Mercury?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty A/C Evaporator Temperature (ACET) Sensor
  • A/C Evaporator Temperature Sensor harness is open or shorted
  • A/C Evaporator Temperature Sensor circuit poor electrical connection
  • Faulty Powertrain Control Module (PCM)
⚠ Does your Mercury have Safety Recalls? → Check here

How to Fix the DTC P1436 Mercury?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P1436 Mercury Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P1436 Mercury code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the P1436 Mercury Code Mean?

The A/C Evaporator Temperature (ACET) sensor contains a thermistor which receives a reference voltage from the Powertrain Control Module (PCM). The thermistor then varies the resistance to the reference voltage based on the evaporator discharge air temperature. The resulting voltage is returned to the PCM where it is interpreted as an evaporator discharge air temperature reading.
The PCM maintains evaporator core temperature and prevents icing of the evaporator core, by disengaging the A/C compressor clutch (non-hybrid) or decreasing the electric A/C compressor speed (hybrid) when the evaporator A/C Evaporator Temperature sensor reading falls below acceptable levels, and by engaging the A/C compressor clutch (non-hybrid) or increasing the electric A/C compressor speed (hybrid) when the discharge air temperature rises above acceptable levels.
The A/C Evaporator Temperature sensor is located inside of the heater core and evaporator core housing in the air-stream leaving the evaporator core.
The Diagnostic Trouble Code (DTC) Indicates the ACET signal input is less than Self-Test minimum. The Self-Test minimum is 0.13 volts.

P1436 Mercury Code - A/C Evaporator Air Temperature Circuit Low

Need more Information on the Code?

Need more information on how to fix the P1436 Mercury code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P1436 Mercury code diagnosed by a professional: Find a repair shop in your area