Engine-Codes -
Buick -
P1416 BUICK
P1416 BUICK - Secondary Air Injection System Bank 2
Table of contents
P1416 BUICK Possible Causes
- Faulty Secondary Air Injection (AIR) pump
- Secondary Air Injection check valve bank 2
- Secondary Air Injection (AIR) pump electrical circuit fault
- Blocked Secondary Air Injection (AIR) system
How is the P1416 BUICK code repair?
Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.What is the cost to diagnose the P1416 BUICK code
Labor: 1.0
The cost to diagnose the P1416 BUICK code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
When is the code detected?
The P1416 code is set when no O2 sensor voltage change is detected by the Engine Control Module (ECM).Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P1416 BUICK Meaning
A Secondary Air Injection (AIR) pump is used on this vehicle to lower tail pipe emissions on start-up. The Powertrain Control Module (PCM) supplies a ground to the AIR pump relay, which energizes the AIR pump. The PCM monitors the HO2S voltages to diagnose the AIR system. During the AIR test, the PCM activates the AIR pump during closed loop operation. When the AIR is activated, the PCM monitors the HO2S voltages and short term fuel trim values for both banks of the engine. If the AIR system is operating properly, the HO2S voltages should go low and the short term fuel trim should go high.More Information
Need more information on how to fix the P1416 BUICK code?Get Access to Factory Service Manuals