P1336 Dodge Code - No 5Vs To Throttle Position Sensor
Quick Answer
The P1336 diagnostic trouble code (DTC) for Dodge vehicles indicates that there is no 5-volt reference signal reaching the throttle position sensor (TPS). Common causes include Faulty throttle position sensor, Damaged wiring or connectors in the 5-volt reference circuit, Malfunctioning engine control module (ECM). Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
- What it means
- P1336 Dodge indicates No 5Vs To Throttle Position Sensor.
- Common causes
- Common causes include Faulty throttle position sensor, Damaged wiring or connectors in the 5-volt reference circuit, Malfunctioning engine control module (ECM).
- Severity
- High - diagnose this code as soon as possible.
- Can I drive?
- Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
Code P1336 Dodge Description
The P1336 diagnostic trouble code (DTC) for Dodge vehicles indicates that there is no 5-volt reference signal reaching the throttle position sensor (TPS). The throttle position sensor is a crucial component of the engine control system, as it communicates the position of the throttle to the engine control module (ECM). The ECM uses this information to adjust the air-fuel mixture and ignition timing to optimize engine performance and fuel efficiency.
Common Causes of P1336 Dodge
- Faulty throttle position sensor
- Damaged wiring or connectors in the 5-volt reference circuit
- Malfunctioning engine control module (ECM)
- Corrosion or poor connections in the electrical system
- Short circuit in the 5-volt reference circuit
Symptoms of P1336 Dodge
- Poor engine performance or responsiveness
- Stalling or rough idling
- Hesitation or surging during acceleration
- Illumination of the Check Engine Light
- Limp mode activation
How to Fix P1336 Dodge
- Begin by performing a thorough inspection of the throttle position sensor, wiring, and connectors for any signs of damage or corrosion.
- Test the 5-volt reference circuit to ensure that the proper voltage is reaching the TPS.
- If the voltage is not within the specified range, diagnose and repair any wiring or connector issues.
- If the wiring and connectors are in good condition, replace the throttle position sensor with a new, OEM quality part.
- Clear the DTC and perform a test drive to verify that the issue has been resolved.
Cost to Fix P1336 Dodge
The cost of repairing a P1336 code on a Dodge vehicle can vary depending on the specific cause of the issue and the labor rates in your area. In general, replacing a throttle position sensor can cost between $100 and $200, including parts and labor. However, if additional repairs or diagnostic procedures are required, the total cost may increase. It's advisable to consult with a qualified mechanic or repair shop to obtain a more accurate estimate based on your vehicle's make and model. Keep in mind that labor rates can range from $80 to $150 per hour, with rates potentially higher at dealerships or in metropolitan areas.
Need more information about the P1336 Dodge code?
Need more information on how to fix the P1336 Dodge code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P1336 Dodge code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P1336 Dodge Code
No Frequently Asked Questions about P1336 Dodge Code found.
Discuss the causes and fixes for P1336 Dodge OBDII Code
Code P1336 Dodge comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.