P1335 GMC - Crankshaft Position Circuit

Repair Importance Level: 3/3
Repair Difficulty Level: 2/3  What does this mean?

P1335 GMC Possible Causes

  • Faulty Crankshaft Position Sensor
  • Crankshaft Position (CKP) Sensor harness is open or shorted
  • Crankshaft Position (CKP) Sensor circuit poor electrical connection

How do I fix code P1335 GMC

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Cost of diagnosing the P1335 GMC code

    Labor: 1.0

    The cost of diagnosing the P1335 GMC code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

P1335 GMC Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Lack/Loss of Power
  • Engine Stall

P1335 GMC Meaning

The Crankshaft Position (CKP) sensor sends pulses to the Powertrain Control Module (PCM) as the reluctor wheel teeth rotate past the CKP sensor. The PCM uses the CKP pulses to synchronize the ignition and fuel injector operation, and to time the interval between each CKP pulse. The PCM determines when an excessive change in crankshaft speed occurs by comparing each new time interval with the previous interval. A misfire causes an unexpected change in the crankshaft speed. A certain amount of acceleration/deceleration is expected between each firing stroke, but if the crankshaft speed changes more than an expected amount, the PCM interprets this as a misfire. The interval between CKP sensor pulses is extremely small. At high engine speeds, slight variations in the following components make misfire detection difficult:
- Crankshaft
- Reluctor wheel
- CKP sensor
The PCM learns variations during the Crankshaft Position System Variation Learning Procedure. The PCM compensates for these variations when performing detect misfire calculations. Only a scan tool can command the PCM to perform the Crankshaft Position System Variation Learning Procedure again.
Perform the learning procedure after the following actions:
- A PCM replacement
- Any operation or repair involving the crankshaft, the CKP sensor, or the CKP sensor to reluctor wheel gap relationship.
- An engine replacement.
- The ignition switch is in the ON position until the battery is drained.
OBDII Code P1335 GMC - Crankshaft Position Circuit - Engine-Codes.com

P1335 GMC More Information

Need more information on how to fix the P1335 GMC code?
Get Access to Factory Service Manuals

Related Information